Blitz Scion xB-xA Compressor System Manual do Utilizador

Instruction Manual Scion xA/xB 2004-up models 5speed and Automatic Blitz Global Network Authorized Distributor

(6) Manifold and compressor mounting Note: Torque Specification Ｍ６ 7.38 Lbs/Inch Ｍ８ 13.6 Lbs/Inch Ｍ１０

4. Remove the alternator bracket as shown in the illustration. 5. Using the ⑥ bolt (1) and #17 bracket

11. Attach #21 Nipples (2) to #4 Inlet pipe. *Please use teflon tape to ensure

15. Attach compressor onto the intake manifold. Make sure the #5 Compressor gasket (1) is installed.

19. Remove bolt from the fuel delivery pipe bracket. 20. Remove the 2 bolts holding do

H 30. Zip ties Ｌ①Flange bolt ② Flange bolt 2. Cover ⑧Hex bolt ⑮Washer 10. Trans. bracket ①Bolt ⑫Nut

29. Using #27 Silicon hose, and #28 hose clamp (2) attach the #4 inlet pipe. Attached temporarily. 30. Using ⑩ Allen b

33. Use #19 throttle body gasket and reinstall the throttle body and the throttle cable bracket. * Us

38. To secure compressor harness, use the factory valve cover bolt as shown in illustration. 13. Ad

Part 39. Wiring and routing of relay harness In the Engine Bay 1. Connect the female relay harness pl

Safety Note In beginning * Please read this throughly and fully understand this instruction manual. * Please have a factory service manual on h

加工部分 Part 40. Switch controller and bezel installation. 1. The nut and the washer of the switch controller are re

ECU/Under Dash wiring (Wiring for the activati

Blue Wire Corresponding color code chart B-O=black/

Front of Car 39. Locate main fuse box under the hood. Remove the fuel pump relay (listed asAM2)

(3) Part list 1.Compressor Assy x1 2. Compressor tube x1 3. Intake manifold x 1 4. Intake pipe

21. Vacuum fitting large x 2 22. Vacuum fitting small x 1 27．Silicone hose x１23．S/C activation box

(4) Relieving fuel pressure on fuel pump Under Dash Fuse box 40．Switch tem

(5) Removal of OEM/factory parts 1. Remove engine

4. Remove air bag sensor. *WARNING Make sure the battery is disconnected* 5. Remove

10. Remove Throttle Cable. 11. Remove

12. Remove blow-by hose and vacuum hose as shown in illustration. 13. Remove the bolt (1